E-mail China English

Contact Us
Address:2F No16 Block, High technology industry park ,ZHUANKOU Developing District ,WUHAN ,China
Domestic trade:Wilson             Tel:1530 7135 737
International trade:Regina
Tel:1365 7240 594

Tel:+86-27-83496953
                +86-27-83496752
Fax:      +86-27-84478927

E-mail: info@jutasolar.net
  • Product Name: CM50 Intelligent Solar Charge Controller
  • Model: CM50
  • Views : 1347

QQ chat

 

CM50 Intelligent Solar Charge Controller

 

CM series controller is a kind of intelligent, multi-purpose solar charge and discharge controller. The family use the fixed LCD display, with a very friendly interface;

various control parameters can be flexibly set, fully meet your various application requirements.

CM series controller has following features:

Image of LCD graphic symbol;Simple button operation;Automatic Identification System Voltage level;Intelligent PWM charge mode;Automatic Temperature Compensation;Adjustable charge-discharge control parameters;Settable Operating mode of Load;Remote monitoring and control function (custom);Accumulated function of charge and discharge Ampere hours

Protection functions:

  • Overload, Short Circuit Protection
  • Battery Low Voltage Disconnection (LVD)
  • Battery reverse-discharge protection
  • Battery reverse connection protection

 

Technical Data

 

 

Model
CM5024Z CM5048
Rated Current 50A 50A
Rated Voltage 12V/24V 48V
Solar Panle Voltage 50V 100V
Float Charging Voltage 13.8V/27.6V 55.2V
Low Voltage disconnecting 10.7V/21.4V 42.8V
Low Voltage Recovery 12.5V/25.0V 50.0V
No load loss 30mA 30mA
Loop Voltage Drop 170mV 170mV
Charging mode PWM
Temperature compensation -4mV/Cell/
Note Model suffix "Z" represent automatic identify system voltage level,"T"represent controller with remote monitoring.

Installation


Install:
①  Get ready for tools and cables. Advising you to matching the right cables. Ensure that the current density <4A/mm²  that is conductive to reducing the line voltage drop. Recommendation: 30A with 10mm² cables. Check whether the installation sites compliance with the relevant safety requirements. Please avoid the damp, dusty, there is a place flammable, explosive and corrosive gases use the controller to install.    
② Install the controller into a fixed vertical plane. See section 5 of the pore size and pore spacing. In order to ensure a good thermal control conditions, please set aside each 10cm below the controller space.
③ As shown on the right, connect the (1) Load, (2) Battery and (3) Solar Panel to the controller according to the order of (1) (2) (3). Pay attention to the load, battery, solar panel and controller of same polarity.
④ Put the external temperature sensor into the left of the controller (probe port). The temperature sensor should be placed at the similar space of the battery. (Otherwise, the controller will control the parameters of all wrong temperature compensation.)
⑤ If you have remote monitoring and control function, please insert one end of the included communication wire on the right of the controller (communication port), the other end to connect to the host computer.
Demolition: To prevent accidents, please order the demolition of solar panels, battery and load disconnect with controller.
Note:Battery polarity will not damage the controller, but you will have a load equipment security risks.

Installtion cable area

 >3# AWG ( 25mm2 )

Operation temperature

-20℃ ~ 50℃

storage temperature

-30℃ ~ 70℃

Humidity requirement

 <90% , no condensation

Size

 130mm*188mm*62mm

Mounting hole spacing

 90 mm 178 mm --Ö5

Weight

590g